IOLM 8-PNIO Connecting to the Network
The IOLM 8-PNIO provides two Fast Ethernet (10/100BASE-TX) M12 connections (4-pin female /D-coded).
You can use this procedure to connect the IOLM 8-PNIO to the network.
Securely connect one end of the M12 Ethernet cable to EIP 1 or EIP 2.
Connect the other end to the network.
Optionally, you can use the other Ethernet port to daisy-chain to another Ethernet device.
If you did not connect both Ethernet ports, make sure that screw on a connector cap,
which was shipped with the IOLM 8-PNIO to keep dust and liquids from getting in the connector.
Ethernet ports must have an approved cable or protective cover attached to the port guarantee IP67 compliance.