Comtrol Logo

 Downloads
 DeviceMaster
 IO-Link Block
 IO-Link Master
 EtherNet/IP
 PROFINET IO
 Installation 4-PNIO
 Installation 8-PNIO
 Rotary Switch
 Connect Network
 Connect Power
+Mount/Installation
 Connect Devices
 Installation 8-PNIO-L
 Installation DR-8-PNIO
 Installation DR-8-PNIO-P
 Installation DR-8-PNIO-T
 PortVision DX
 Software
 Common Procedures
 Documentation
 Troubleshooting
 RocketLinx
 RocketPort
 RocketPort USB Serial Hub II
 Troubleshooting
 Obsolete/Legacy Files
 Support Contribs Directory
 Comtrol Forum
 Lodging Link Online Support
 Download Issues
 Report Site Issues

Mounting the IOLM 8-PNIO

Use the following procedure to mount the IO-Link Master. The IO-Link Master can be installed on a mounting panel or a machine.

  1. Verify that the mounting surface is level (flat) to prevent mechanical stress to the IO-Link Master.

  2. Attach the IO-Link Master to the surface with two 6mm screws and washers.

  3. Attach the grounding strap to chassis or earth ground.

  4. Torque down to 8Nm.

  5. Make sure that you connect the FE terminal at low impedance to function ground to meet EMC standards.
nice color
02/06/20Home | Comtrol Website 
Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.