You can also refer to the IO-Link Master Library for EtherNet/IP and Modbus/TCP for detailed installation and configuration procedures. Also, the IO-Link Master web interface help system provides detailed information.

Note
The IO-Link Master DR-EIP must be installed in a suitable fire, electrical, mechanical area.

The following provides an installation and configuration overview for the IOLM DR-8-EIP.

Install the IOLM DR-8-EIP hardware.
1. Connect to the network.
2. Connect and apply the power.
3. Connect the IO-Link devices.
4. If desired, connect digital input or output devices to the digital IO ports.
5. If desired, mount the IO-Link Master.
Configure the IP address using the IO-Link Master web interface or PortVision DX.
Configure the port characteristics using the embedded web interface.
Optionally, use the IO-Link Master to configure/edit IO-Link device parameters. The IO-Link Master web interface provides:
- IO-Link Device Description GUI that works in conjunction with the device manufacturers IODD files, which you can load on the IO-Link Master.
- IO-Link Device ISDU Interface, which can be used referencing device manufacturers Operator or Configuration Manuals that contain the ISDU Block Index and ISDU Sub-Index parameters.
Optionally, implement these features after configuring the IO-Link device: Data Storage (Automatic or Manual), Device Validation Mode, and Data Validation Mode.
Optionally, use the EDS files and/or example programs to prepare PLC programs.

	02/06/20	Home \| Comtrol Website
	Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.