Comtrol Logo

 Downloads
 DeviceMaster
 DM/PRO/RTS/Serial Hub
 EIP
 EIP-MOD
 LT
 Firmware
 Device Drivers
 Installation Overview
 Hardware Install
 Program IP Address
+Program IPv6 Address
 Firmware Procedures
 NS-Link Drivers
 Configure Ports
 PortVision DX and Utilities
 Supporting Documents
 Troubleshooting
 MOD
 PNIO
 UP
 IO-Link Block
 IO-Link Master
 RocketLinx
 RocketPort
 RocketPort USB Serial Hub II
 Troubleshooting
 Obsolete/Legacy Files
 Support Contribs Directory
 Comtrol Forum
 Lodging Link Online Support
 Download Issues
 Report Site Issues

DeviceMaster LT Programming an IPv6 Address

After installing the hardware, you can program the network information (IPv6 address) into the DeviceMaster LT.

If you want to program an IPv6 address, you have two methods available:

  • Use the DeviceMaster web page (SocketServer/NS-Link) by initially accessing the web page with an IPv4 address.

    [Note]
    Note

    The default IPv4 address is 192.168.250.250. You can use PortVision DX to program an IPv4 address.

  • Use the IPv6 link local address in a browser that support IPv6.

This procedure supports SocketServer v11.00 or higher.

  1. If necessary, configure an IPv4 using PortVision DX.

  2. Open your browser and enter the IP address.

  3. Click Network.

  4. If desired, click Disable IPv4 networking.

  5. Click either User DHCPv6 or Use static config below depending on your network requirements.

    1. If you selected Use static config below, enter the IPv6 address.

    2. Enter the prefix length. 64 is the smallest recommended prefix length.

    3. Enter the Gateway address.

  6. Click Save.

    [Note]
    Note

    You must reboot for changes on this page to take affect.

  7. Click System | Reboot.

  8. Optionally, click the Reboot Now button or let the web page reboot using the timer.
nice color
02/06/20Home | Comtrol Website 
Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.