After programming the IP address into the DeviceMaster EIP-MOD, you are ready to update the DeviceMaster EIP-MOD with the latest EtherNet/IP - Modbus firmware.

Note

Use PortVision DX to upload the DeviceMaster firmware files or optionally, the Firmware Uploader Utility for Linux.

DeviceMaster EIP-MOD requires PortVision DX v4.10 or higher.

Name

Released

Beta

Description

DeviceMaster EIP-MOD firmware

16-port NOT Supported

Requires Windows XP SP3 or higher

v1.01

You may need to upload the DeviceMaster EIP-MOD firmware on the DeviceMaster EIP-MOD using PortVision DX before configuring the serial ports.

Refer to the DeviceMaster EIP-MOD Hardware Installation and Configuration Guide for detailed information about uploading firmware.

For secure configuration procedures, see the DeviceMaster Secure Configuration User Guide.

Bootloader

v4.31

Bootloader is the RedBoot operating system that runs the device during the power on phase, which then starts the default application on the DeviceMaster EIP-MOD.

You should check the Bootloader version and if necessary, update Bootloader.

You can review the firmware History file for the latest updates and enhancements.

Note
Pepperl+Fuchs Comtrol, Inc. recommends verifying that the DeviceMaster EIP-MOD contains the latest EtherNet/IP - Modbus version before configuring serial ports.

	02/06/20	Home \| Comtrol Website
	Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.