Programming the IP Address

Install PortVision DX.

Start PortVision DX using the PortVision DX desktop shortcut or from the Start button, click Programs | Comtrol | PortVision DX.

If this is the first time you have opened PortVision DX, click the Scan button.

Select the Pepperl+Fuchs Comtrol, Inc. Ethernet-attached device types that you would like to locate and then click the Scan button.

Note PortVision DX will locate all Pepperl+Fuchs Comtrol, Inc. Ethernet-attached managed devices when on the local network segment, excluding the DeviceMaster FreeWire.

Right-click the DeviceMaster EIP-MOD for which you want to program network information and open the Properties screen using one of these methods.

Note You can use the help system for information about using PortVision DX.

Optionally, enter a friendly name for the DeviceMaster EIP-MOD in the Device Name field, which displays in the Device Tree or Device List pane on the main page.

The MAC address is automatically loaded and cannot be changed.

The Device Status is the same status as listed on the main page.

Select the appropriate Detection Type:

Change the DeviceMaster EIP-MOD network properties as required for your site.

Click Apply Changes to update the network information on the DeviceMaster EIP-MOD.

Click Close to exit the Properties window.

After configuring the network, you are ready to check the firmware version before configuring the ports.