Comtrol Logo

 Downloads
 DeviceMaster
 IO-Link Block
 IO-Link Master
 EtherNet/IP
 Installation 4-EIP
 Installation 8-EIP
 Installation 8-EIP-L
 Rotary Switch
+Connect Network
 Connect Power
 Mount/Installation
 Connect Devices
 Set IP Address
 Configure Ports
 Installation DR-8-EIP
 Installation DR-8-EIP-P
 Installation DR-8-EIP-T
 PortVision DX
 Software
 Common Procedures
 Documentation
 Troubleshooting
 PROFINET IO
 RocketLinx
 RocketPort
 RocketPort USB Serial Hub II
 Troubleshooting
 Obsolete/Legacy Files
 Support Contribs Directory
 Comtrol Forum
 Lodging Link Online Support
 Download Issues
 Report Site Issues

IOLM 8-EIP-L Connecting to the Network

The IOLM 8-EIP-L provides two Fast Ethernet (10/100BASE-TX) M12 connections (4-pin female /D-coded).

Ethernet Connectors
PinSignal

1

Tx+

2

Rx+

3

Tx-

4

Rx-

You can use this procedure to connect the IOLM 8-EIP-L to the network.

  1. Securely connect one end of the M12 Ethernet cable to EIP 1 or EIP 2.

  2. Connect the other end to the network.

  3. Optionally, you can use the other Ethernet port to daisy-chain to another Ethernet device.

  4. If you did not connect both Ethernet ports, make sure that screw on a connector cap, which was shipped with the IOLM 8-EIP-L to keep dust and liquids from getting in the connector.

[Note]
Note

Ethernet ports must have an approved cable or protective cover attached to the port guarantee IP67 compliance.
nice color
02/06/20Home | Comtrol Website 
Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.