DeviceMaster EtherNet/IP Common Procedures

This section provides installation and configuration procedures that are typical DeviceMaster Industrial Gateways regardless of the industrial protocol. The Pepperl+Fuchs Comtrol, Inc. DeviceMaster Industrial Gateway includes DeviceMaster UP, DeviceMaster EIP, and DeviceMaster MOD models.

Hardware installation
Install PortVision DX, an application that you can use to manage the DeviceMaster Industrial Gateway and upload firmware

Note
PortVision DX requires a Windows operating system.
Program the IP address using PortVision DX
Firmware procedures, for example:
- Checking the protocol version
- Uploading the protocol
- Checking the Bootloader version
- Uploading Bootloader

You may need upload the appropriate firmware for your protocol using PortVision DX. Depending on the DeviceMaster Industrial Gateway model you purchased, the DeviceMaster Industrial Gateway may, or may not have the protocol firmware loaded.

Models that have a protocol loaded on the DeviceMaster Industrial Gateway are identified in PortVision DX and the DeviceMaster Industrial Gateway is labeled accordingly.

	02/06/20	Home \| Comtrol Website
	Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.