The following steps provide an overview of the hardware installation. You can refer to the DeviceMaster UP Hardware Installation and Configuration Guide (Rev K) for detailed hardware installation procedures for your model.

Note
PROFINET CbA supports 1-port models and does not support 2-port or 4-port models.

Record the MAC address, model number, and serial number of the DeviceMaster UP.
If necessary, mount the DeviceMaster UP.
Connect the DeviceMaster UP to the same Ethernet network segment as the host PC using a standard network cable.
Apply power to the DeviceMaster UP by connecting the AC power adapter to the DeviceMaster UP, the appropriate power cord for your location to the power adapter, and plugging the power cord into a power source.

Verify that the Status LED has completed the boot cycle and network connection for the DeviceMaster UP is functioning properly using the following table.

LED

Description

Status or PWR

4-port models have a PWR LED on the reverse side from the serial connectors.

If lit, the Status or PWR LED indicates the DeviceMaster UP has power and completed the boot cycle.

Note
The Status LED flashes while booting and it takes approximately 15 seconds for the Bootloader to complete the cycle. When the Bootloader completes the cycle, the LED has a solid, steady light that blinks approximately every 10 seconds.

Link/Act

LNK ACT (UP/DOWN)

1- and 4-Port Models

If the Link/Act or LNK ACT LED is lit, it indicates a working Ethernet connection.

LINK

2-Port Models

If the LINK (green) LED is lit, it indicates a working Ethernet connection.

Duplex

1-Port Models

If the Duplex LED is lit, it indicates full-duplex activity.

ACT

4-Port Models

If the ACT (yellow) LED flashes, it indicates network activity

COL

4-Port Models

If the COL LED is lit, there is a network collision.

100

1- and 4-Port models

If the 100 LED is lit, it indicates a working 100 MB Ethernet connection (100 MB network, only). If the LED is not lit, it indicates a 10 MB Ethernet connection.

Configure the DeviceMaster UP IP address.

	02/06/20	Home \| Comtrol Website
	Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.