RocketPort 550 Universal PCI
Device Drivers and Driver Installation Documents
Use this table to access the device driver and installation document for your operating system.
|Operating System||Device Driver||Installation Document|
|Release Rev K, 28th September 2006
|Release Rev D, 17th December 2007
Windows Server 2003
|Release Rev M, 12th December 2007
|Release Rev N, 17Th December 2007
|Release Rev L 15th September 2003
|Release Rev J, 22nd September 2003
You can create a Diagnostic diskette or CD to:
Confirm that the hardware is functioning.
Determine resolutions to conflicts during installation.
Perform a stress test on the ports.
For example, you may want to run the diagnostics stress test overnight to evaluate a possible problem.
You will need loopback plugs for each port that you want to test.
Copy the .iso file
to a temporary location.
Burn the image to a CD-ROM.
An .iso file cannot be copied onto a CD but must be burned using an application
that burns the image to the CD. If you do not have an application available,
you can use this freeware application.
To start the diagnostic, reboot your system with the Diagnostics CD in the drive and follow the instructions in the diagnostic.
If the Diagnostic CD does not boot the PC,
you may need to change your BIOS settings so that the PC can boot from a CD drive.
Use the following procedure to create a bootable diskette.
This procedure requires one blank diskette.
Copy the diskette image file to a temporary location.
When prompted for a file name, enter the diskette image file name; for example: 1800125d.i
To start the diagnostic, reboot your system with the diskette in the drive and follow the instructions in the diagnostic.