After programming the IP address into the DeviceMaster UP, you are ready to upload or update the DeviceMaster UP with the PROFINET IO firmware. Depending on the model you purchased, it may or may not have PROFINET IO loaded. The DeviceMaster UP may contain SocketServer, the default application from the factory.

Models that have a protocol loaded on the DeviceMaster UP are identified in PortVision DX and the DeviceMaster UP is labeled accordingly.

Note
You will need PortVision DX (v3.03 or higher) to upload the DeviceMaster firmware (.cmtl) files. Optionally, you can use the Firmware Uploader Utility for Linux (v1.06 or higher).

Name

Files

Description

PROFINET IO firmware

Supports 1-Port Panel Mount and 2-Port DIN Rail Models with serial numbers below 30000

v2.25_cmtl

You may need to upload PROFINET IO firmware to the DeviceMaster UP using PortVision DX before configuring the serial ports.

Refer to the PROFINET IO User Guide for detailed information about PROFINET IO and configuration.

If you need hardware information, refer to the DeviceMaster UP Hardware Installation and Configuration Guide.

Note

Pepperl+Fuchs Comtrol, Inc. recommends verifying that the DeviceMaster UP contains the latest PROFINET IO version before configuring serial ports.

If your DeviceMaster UP model was shipped with PROFINET IO, you should check the firmware version and if necessary, upload the latest version of PROFINET IO using PortVision DX.

	02/06/20	Home \| Comtrol Website
	Copyright © 2020 Pepperl+Fuchs Comtrol, Inc.